Abstract
Objective
The main objective of this study was to demonstrate that dental implants made from ultrafine‐grain titanium (UFG‐Ti) can be created that replicate state of the art surfaces of standard coarse‐grain titanium (Ti), showing excellent cytocompatibility and osseointegration potential while also providing improved mechanical properties.
Material and methods
UFG‐Ti was prepared by continuous equal channel angular processing (ECAP) and surfaces were treated by sand‐blasting and acid‐etching. Mechanical properties (tensile and fatigue strength), wettability and roughness parameters were evaluated. Human trabecular bone‐derived osteoblast precursor cells (HBCs) were cultured on all samples to examine cytocompatibility and mineralization after 4 and 28 days, respectively. Biomechanical pull‐out measurements were performed in a rabbit in vivo model 4 weeks after implantation.
Results
Both yield and tensile strength as well as fatigue endurance were higher for UFG‐Ti compared to Ti by 40%, 45% and 34%, respectively. Fatigue endurance was slightly reduced following surface treatment. Existing surface treatment protocols could be applied to UFG‐Ti and resulted in similar roughness and wettability as for standard Ti. Cell attachment and spreading was comparable on all samples, but mineralization was higher for the surfaces with hydrophilic treatment with no significant difference between UFG‐Ti and Ti. Pull‐out tests revealed that osseointegration of surface treated UFG‐Ti was found to be similar to that of surface treated Ti.
Conclusion
It could be demonstrated that existing surface treatments for Ti can be translated to UFG‐Ti and furthermore, that dental implants made from surface‐treated UFG‐Ti exhibit superior mechanical properties while maintaining cytocompatibility and osseointegration potential.
This article is protected by copyright. All rights reserved.
from OroFacial via a.sfakia on Inoreader https://ift.tt/2QiW28F
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.